Burkert 1087 Manual De Instrucciones página 18

CHANGING THE TIMER FUNCTION
• Function 'A' - start with the ON time and then the OFF time, etc.
• Function 'C' - start with the OFF time and then the ON time, etc.
• Function 'B' - single shot, starts with the ON time and then switches OFF indefinite.
• Function 'D' - single shot, starts with the OFF time and then switches ON indefinite.
• Function 'E' - start with ON time then OFF time and then switches ON indefinite.
• Function 'F' - start with OFF time then ON time and then switches OFF indefinite.
THE TIMER IS FACTORY SET TO FUNCTION 'A'. FOLLOW THESE STEPS TO CHANGE THE TIMER FUNCTION:
1. Disconnect the unit from the power supply.
2. Press and hold down the 'TEST' button and connect the unit to the power supply.
3. Release the 'TEST' button after the current timer function appears on the display (A/ B/ C/ D/ E or F).
4. Use 'off/arrow down' and 'on/arrow up' buttons to select the function (A/ B/ C/ D/ E or F).
5. When the function is selected do not press anything, after a few seconds the unit will resume operation with the new function
setting.
6. Change the pre-set ON and/or OFF times if required.
RETURNING TO THE FACTORY SETTINGS
Factory settings of the timer: 3 seconds ON time, 30 minutes OFF time, function 'A'.
No matter how you change the settings you can always reset all settings to factory settings.
To do so please follow these easy steps:
1. Disconnect the unit from the power supply.
2. Press and hold down 'off/arrow down' and 'TEST' buttons, connect the unit to the power supply.
3. Release the buttons after 'P' appears on the display.
4. When 'A' appears on the display, do not press anything.
5. After a few seconds the unit will resume operation with factory settings.
18