Publicidad
HDMI™ Splitter 1 to 4 (4K @ 30 Hz)
EN
Répartiteur HDMI™ 1 vers 4 (4K @ 30 Hz)
FR
• Do not short-circuit connectors and circuits.
A defective device may not be put into operation, but must
be disconnected from mains and protected against fur-
ther use.
• Use product, product parts and accessories only in per-
fect condition.
• Avoid stresses such as heat and cold, moisture and di-
rect sunlight, microwaves, vibrations and mechanical
pressure.
• In case of questions, defects, mechanical damage, trou-
ble and other problems, non-recoverable by the docu-
mentation, contact your dealer or producer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against ac-
cidental use.
Heat storage
• Do not cover the product.
• Keep enough space around all devices for a good ventla-
tion and free motion and to avoid damages.
2 Description and function
2.1 Product
The product is an HDMI™ splitter including power supply
that transmits one input signal (audio and video) to four out-
put devices simultaneously.
2.2 Scope of delivery
HDMI™ Splitter 1 to 4 (4K @ 30 Hz), Power supply, Char-
ging cable, User Manual
2.3 Operating Elements
See Fig. 1.
1 DC socket
2 HDMI™ socket (output)
3 HDMI™ socket (input)
4 LED status indicators
5 ON/OFF switch
3 Intended use
This product is intended exclusively for private use
and its intended purpose. This product is not inten-
ded for commercial use. We do not permit using
the device in other ways like described in chapter „Descripti-
on and Function" or in the „Safety Instructions". Use the pro-
duct only in dry interior rooms. Not attending to these regu-
lations and safety instructions might cause fatal accidents,
injuries, and damages to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and in-
tegrity.
2. Compare the specifications of all used devices and en-
sure compatibility.
5 Connection and operation
NOTICE!
• Switch off the splitter before connecting or disconnecting
your source and output devices via the HDMI™ sockets.
See Fig. 2.
1. Connect one source device to the HDMI™ socket (in-
put) (3) of the splitter.
2. Connect up to four output devices to the HDMI™ sockets
(output) (2) of the splitter.
Connection cables are not included in the delivery. Make
sure that the source and output devices as well as the con-
nection cables support the resolutions and standards of
the product!
3. Connect the USB-A plug (8) of the charging cable to the
USB-A socket (7) of the power supply.
4. Plug the Euro plug (6) of the power supply into a free
and easily accessible socket.
5. Connect the DC plug (9) of the charging cable to the DC
socket (1) of the splitter.
6. Press the ON/OFF switch (5) to turn on the splitter.
The splitter is now supplied with power and is switched on.
The LED status indicator (4) „Power" lights up red.
If the source device and the output devices are correctly
connected and switched on, the respective LED status indi-
REV2022-11-11
Subject to change without notice. |
V1.0aw
Sous réserve de modifications.
6 Euro plug
7 USB-A socket
8 USB-A plug
9 DC plug
Material damage
cators (4) light up green.
If the output devices support different resolutions, the lo-
west resolution is automatically displayed on all output de-
vices.
7. After use, switch off the splitter by pressing the ON/OFF
switch (5) again and disconnect all cable connections.
6 Maintenance, Care, Storage and
Transportation
The product is maintenance-free.
NOTICE!
• Always disconnect the mains plug before cleaning.
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry
and dust-protected ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.
7 Disposal instructions
According to the European WEEE directive, electri-
cal and electronic equipment must not be disposed
with consumers waste. Its components must be re-
cycled or disposed apart from each other. Otherwise
contaminative and hazardous substances can damage the
health and pollute the environment.
As a consumer, you are committed by law to dispose electri-
cal and electronic devices to the producer, the dealer, or pu-
blic collecting points at the end of the devices lifetime for
free. Particulars are regulated in national right. The symbol
on the product, in the user manual, or at the packaging all-
udes to these terms. With this kind of waste separation, ap-
plication, and waste disposal of used devices you achieve
an important share to environmental protection.
WEEE No: 82898622
1 Consignes de sécurité
Le mode d'emploi fait partie intégrante du produit et com-
prend d'importantes informations pour une bonne installati-
on et une bonne utilisation.
• Lisez le mode d'emploi attentivement et complètement
avant de l'utiliser.
Le mode d'emploi doit être disponible à des incertitudes et
transfert du produit.
• Conservez soigneusement ce mode d'emploi.
Sans surcharge de tension uniquement lorsque le bou-
chon est tiré.
• En cas d'urgence, après l'utilisation et pendant un orage,
retirez la fiche secteur de la prise directement au niveau
du boîtier de la fiche.
• Ne pas ouvrir le boîtier.
• Ne modifiez pas le produit et les accessoires.
• Pas court-circuiter des connexions et circuits.
Un appareil défectueux ne doit pas être mis en service. Il
doit au contraire être immédiatement mis hors tension et
protégé contre toute utilisation involontaire.
• Utilisez le produit, pièces et accessoires des produits
uniquement en parfait état.
• Éviter des conditions extrêmes, telles que la chaleur ex-
trême et froid, l'humidité et de la lumière directe du so-
leil, ainsi que microondes, des vibrations et de la pressi-
on mécanique.
• En cas de questions, les défauts, les dommages mécani-
ques, des ingérences et d'autres problèmes, non récupé-
rables par la documentation, contactez votre revendeur
ou le producteur.
Non destiné à des enfants. Le produit n'est pas un jouet !
• Sécuriser l'emballage, petites pièces et l'isolation contre
l'utilisation accidentelle.
Accumulateur de chaleur
• Ne couvrez pas le produit.
• Laissez toujours suffisamment d'espace qu'autour du
système afin de garantir une ventilation appropriée et de
l'espace entre les appareils pour ne pas risquer de les
dommager.
- 3 -
Pillmannstraße 12 | 38112 Braunschweig | Germany
58482
Material damage
Goobay® by Wentronic GmbH
Publicidad
