Newlux WindPure Roof W420 Smart Manual Del Usuario página 26

Fan bracket installation
1. Place the lower bracket down through the down rod and tighten it.
2. Raise the upper bracket and tighten it with the screws. Make sure
that the upper canopy does not touch the ceiling (leaving a 5 mm
gap).
Fan balancing
If the fan becomes unbalanced during operation, perform the following
steps to troubleshoot the problem:
Balancing kit
1. Tighten all screws.
2. Unscrew the blades and fix them in the different position
combinations on the motor.
3. Measure the level between the ceiling and all blades.
4. Use the supplied blade balancing kit if the fan still wobbles.
| 26
>5mm.
Top support
Bottom support
>2,4m.
Plastic clip