Descargar Imprimir esta página

JAROLIFT TDRCT04W Instrucciones Originales página 21

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
For setting the end positions of the controlled radio drive as well as for further settings or programming steps
you need the instructions for the respective radio motor or external radio receiver!
INITIAL PROGRAMMING TDRCT04W - TEACH WALL TRANSMITTER INTO RECEIVER
The example shown is exemplary and depends on the respective receiver type.
Please refer to the instructions of the receiver!
NOTE!
Each key must be pressed (held) for approx. 1 second!
Each programming step must be carried out within approx. 10 seconds.
Otherwise, the system automatically exits the programming mode. If necessary, start from the begin-
ning.
1. Select the desired channel with the K3 key.
2. Set the desired radio receiver or radio motor to programming mode according to the associated instructions.
3. Stellen Sie den gewünschten Funkempfänger oder Funkmotor gemäß der zugehörigen Anleitung in den Programmiermo-
dus.
4. Then immediately press the stop button on the wall transmitter.
5. Successful teach-in is acknowledged by a short vibration of the tubular motor connected to the radio receiver or the vibra-
tion of the radio motor. vibration of the radio motor.
Mo
programming mode
1
2
3
4
programming mode.
Select the desired
channel with the
K3 key (e.g. chan-
nel 2).
If you want to control more receivers with this transmitter/channel, repeat the procedure.
ATTENTION!
Check the function with the UP/STOP/DOWN buttons on the wall transmitter.
If the direction of rotation of the motor is incorrect (roller shutter / motor moves downwards when the UP but-
ton is pressed), the direction of rotation of the motor must be changed.
Please refer to the chapter "Changing the direction of rotation" of the respective radio motor or radio
receiver.
Radio receiver in
(see instructions
Radio receiver)
down buttons simul-
Mo
1
2
3
4
Press the up and
taneously.
PROGRAMMING
Mo
1
2
3
4
Stop button press.
Motor vibrates.
Wall transmitter
is taughtin.
M
21

Publicidad

loading