WERKU WK402080 Instrucciones Originales página 5

ENG ORIGINAL INSTRUCTIONS
DESCRIPTION OF THE PRODUCT.
This hot air gun has been designed to carry out jobs
of expelling air at high temperatures for household
applications, not for
applications. Refer to this plan to familiarize yourself
with the hot air gun before use.
2
1
1. Air exit.
2. Accesories support.
3. Switch.
4. Temperature regulator.
USE INSTRUCTIONS.
Before starting up the hot air gun, we recommend
that you carefully read all of the instructions as
indicated. Please respect all regulations regarding the
prevention of accidents, health and safety directives,
laws and applicable restrictions for work places. The
hot air gun must only be used by persons who have
been instructed in its use and only for the purposes
for which it has been designed.
WARNING!
A fire may result if this hot air gun is not used with
care, therefore. Be careful when using in places where
there are combustible materials. Do not apply to the
same place for a long time. Do not use in presence of
an explosive atmosphere. Heat may be conducted to
combustible materials which are out of sight. Place on
its stand after use and follow to cool before storage.
POWER SUPPLY.
Make sure the power supply is adapted to the
requirements shown on the information panel of the
hot air gun (1). Using the motor at low voltage will
make it operate slowly. This will reduce performance
and may cause the motor to overheat.
EXTENSION CORD.
If the working area is at some distance from the
power supply, use an extension cord of enough
diameter and quality.
professional or industrial
STARTING UP.
Switch the button to one of the hot air gun's two
operating levels in base of the temperature of the
hot air that is needed (2).
WARNING!
The temperature of air emitted by the hot air gun
may vary depending on the temperature of the
environment cold air.
ACCESSORIES.
The hot air gun offers four air ducting accessories
4
and one scraper (3). Additional safety measures.
Never cover the air intakes as this may damage the
3
hot air gun. Never point the hot air gun at anyone
when it is switched on.
TEMPERATURE REGULATOR.
The position switch (I, II or III) indicates the maximum
heat elements that might work in that position. The
regulator in its back part allows to increase or to
reduce the temperature (4), limited by the position
switch position.
AFTER WORK.
Before turning off the hot air gun, turn the regulator
to a minimum at least for a minute and then turn off
the machine. If doesn´t do it, you burn resistance
and does not enter into the guarantee of the hot
air gun. To prevent accidents, do not put the hot air
gun back in its case until it has cooled completely.
MAINTENANCE.
The hot air gun has been designed for a long
working life with minimum maintenance. Optimum
use depends on correct care of the hot air gun and
regular cleaning. To prevent accidents, always
unplug the hot air gun from the power source
before cleaning or performing any maintenance.
The hot air gun may be cleaned effectively using
compressed air after each use. If compressed air
is not available, use a brush to remove dust from
the hot air gun. Motor ventilation vents and switch
levers must be dept clean and free of foreign
matter. Do not attempt to clean by inserting pointed
objects through openings. Cetain cleaning agents
and solvents damage plastic parts, among them
are gasoline, carbon tetrachloride, chlorinated
cleaning solvents, ammonia and household
cleaners containing ammonia. Do not use any of
these to clean the hot air gun. Should excessive
5
English