JULIUS MAYER JMHS-1 Manual De Instrucciones página 19

1. First, select the desired channel by pressing the K1 or K2 key from the
channels 1 to 15 (selected channel is shown in the display).
Channel 0 = group function. This channel cannot be taught-in separately!
2. Set the receiver (motor/external receiver) to programming mode according to the instructions.
3. Press the P2 programming key (back) 2 times.
4. Press the UP key 1 x.
5. The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
OK! Programming successfully carried out!
6. To program additional channels for additional receivers/motors, start from the beginning.
*The frequency of the beeps or the response of the motor/roller shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver/motor.
Then check the function by pressing the UP/STOP/DOWN keys.
If the direction of rotation of the motor is reversed (roller shutter / motor moves downwards when the UP key is pressed),
please start from the beginning and press the DOWN key after the P2 key instead of the UP key!
This will change the direction of rotation of the motor.
To program several transmitters/channels for ONE motor/receiver, the „Add handheld transmitter" function must be used
(depending on the receiver model). Add handheld transmitter" function must be used (depending on the receiver model),
since - e.g. for radio motors - only one transmitter can be programmed directly into the receiver. Please observe the corres-
ponding instructions of the respective receiver/motor!
PROGRAMMING
Display channel display / function display
Key K1 (channel selection)
Key K2 (channel selection)
UP
Stop
DOWN
P2 key (programming key)
19