Installation Information - NERI POLIS Guia De Instalacion

INSTALLATION GUIDES- LUPOL00

INSTALLATION INFORMATION

Installation must be carried out in
accordance with national standards.
The fi xture must only be used when
complete with safety screen. If the
screen is damaged or broken, the fi xture
must not be used. Restore the original
conditions before reusing.
The fi xture is installed under CL II (or
CL I) protection standards, particular
care must be taken while assembling to
ensure that exposed metal parts do not
come into electrical contact with parts of
the electrical installation connected to
a protection conductor. This light fi xture
must be installed only for the use for
which it was designed, namely for the
illumination of outdoor spaces.
Any other use must be considered to
be improper and dangerous, and the
manufacturer cannot be held liable for
any damage caused by improper and
unreasonable use.
Installation
Unscrew the two screws (M6) from the
upper frame (Fig. 1-2) and lift the cover
(Fig. 3-4). Unscrew the two screws (M8),
and the two washers from the connection
present on the upper frame (Fig. 5). Move
the fork closer (Fig. 6), couple it with the
upper frame connection and tighten the
two screws (M8) and two washers (Fig. 7).
Electrical connection
Loosen the screw (M4) (Fig. 8) and open
the plate on the inside of the fork
(Fig. 9). Insert the power cable into the
pole attachment (Fig. 10) and slide the
cable inside the fork (Fig. 11).
Close the plate (Fig. 12) and connect
the power cable (Fig. 13-14). If the
external fl exible cable of this appliance is
damaged, it must only be replaced
by the manufacturer, its service agent or a
qualifi ed person to avoid danger.
Attaching the luminaire to the support
Insert the device, complete with already
connected cables, into the holder (Fig. 15).
Place the cover back on the upper frame
and tighten the two screws (M6) (Fig. 16).
Orient the device correctly in relation to
the road axis (Fig. 17).
Tighten the two grub screws (M8) on the
device connection and lock the
grub screws with nuts. (Fig. 18).
EN
neri.biz 15