Setting The Temperature - Hobby Easy Breeder Manual De Instrucciones

Digital Incubator for Reptile Eggs
Thank you for purchasing the Easy Breeder. For ideal hatching rates and healthy young animals, please read these operating instruc-
tions before initial operation.
Equipment: The Easy Breeder is supplied with a two-part housing of polystyrene. This is only designed for safe transport of the eggs and is not needed
for normal operation. The incubator housing itself consists of a transparent bottom section of plastic, allowing visual inspection of the eggs in the interior
from all sides. The digital controls, the display indicating the current temperature, relative humidity and a day counter showing how many days your eggs
have been in the Easy Breeder are integrated in the cover. The modern combined heating-ventilation system is a technical highlight. This allows
incubating the eggs with temperatures hardly fluctuating and ensures a first class hatching rate! The sensors for relative humidity and temperature are
safely accommodated under a grid in the cover. Water channels are provided in the floor for regulating the humidity during the breeding and hatching
phases. The second grid included in the delivery is used for incubation on two levels, so that twice the number of eggs can be incubated.
Table of contents:
1. Starting up:

2. Setting the temperature

3. Alarm setting for temperature
4. Alarm setting for relative humidity
5. Defining a restricted temperature range
6. Resetting the day counter / Reset to factory setting
7. Useful hints/Incubation table
8. Cleaning and care of the Easy Breeder
9. Problems and solutions
10. Safety instructions and technical data
1. Starting up:
1.1 First connect the power cable to the Easy Breeder and then plug the connector into the mains socket.
1.2 Now switch on the Easy Breeder by means of the toggle switch.
1.3 An alarm signal sounds. You can terminate alarm signals at any time by pressing the green buttons.
1.4 Open the Easy Breeder fill the 7 water channels using the included bottle. These are located underneath the deposition grid. Each channel has a
capacity for 1 full bottle (approx. 200 ml) of water.
1.5 Set the temperature to the desired value. Different temperatures are required for different reptiles (see incubation table.
2. Setting the temperature:
2.1 Press the button (Set) in the control panel once.
2.2 Press the (+) or (-) button to set the desired temperature.
2.3 Press the (Set) button again to complete the process.
The temperature indicator in the control panel always shows the current temperature. When the Easy Breeder is active, this is indicated by a small lamp
in the (Work) field.
3. Alarm setting for temperature: The factory setting for the temperature alarm is programmed at 1 °C above or below the defined desired
temperature. When this value is exceeded an alarm signal sounded. If you wish to change this setting, proceed as follows:
3.1 Setting the low temperature alarm (AL):
3.1.1 Press and hold the (Set) button for approx. 3 seconds.
3.1.2 Press the (+) or (-) button until (AL) appears in the display.
3.1.3 Press the (Set) button again.
3.1.4 Use (+) or (-) to set the desired low alarm value. The setting range is 0.0 – 15.0 °C. Can be set in 0.1 °C steps.
3.1.5 Press the (Set) button again to finalise the process.
3.2 Setting the high temperature alarm (AH):
3.2.1 Press and hold the (Set) button for approx. 3 seconds.
3.2.2 Press the (+) or (-) button until (AH) appears in the display.
3.2.3 Press the (Set) button again.
6
Dohse Aquaristik GmbH & Co. KG · Otto-Hahn-Str. 9 · 53501 Gelsdorf · Germany · www.hobby-terraristik.com