Metra 95-7383 Instrucciones De Instalación página 4

Attention! The factory panel will be
permanently modified after following
these steps.
1. Remove (4) Phillips screws securing the
bottom of the vents, then unsnap and
remove them.
2. Remove (7) Phillips screws securing the
radio trim panel to the radio panel, then
remove the trim panel. (Figure A)
3. Cut the opening as shown (front of dash
panel shown) to allow room for the new
radio trim panel. (Figure B)
4. Attach the radio trim panels to the radio
panel, then secure with the (7)
factory screws. (Figure C)
Continue to Kit Assembly
4
KIT PREPARATION
(Figure A)
Remove shaded area
(Figure B)
(Figure C)
|
386.257.1187 MetraOnline.com