DASH DISASSEMBLY KIT PREPARATION 1. Unclip and remove the top half of the 1. Cut the shaded area in the sub-dash to steering column shroud and gauge allow room for the aftermarket radio. cluster trim panel. These panels are (Figure A) connected together by a piece of material and will come out as one piece. Continue to Kit Assembly Remove shaded area (Figure A) 2. Unclip and remove the a/c vent panel surrounding the radio. (Figure B) 3. Remove (4) screws securing the radio. Slide the radio out, then unplug and remove the radio. (Figure A) (Figure A) Continue to Kit Preparation (Figure B) 386.257.1187 MetraOnline.com...
KIT ASSEMBLY 1. Secure the radio brackets to the radio trim panel using the (4) #8 x 3/8” Phillips screws provided. (Figure A) 2. Slide the radio into the bracket/panel assembly, then secure it using the screws provided with the radio. (Figure B) 3. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation. 4. Secure the radio assembly to the dash using the factory screws. (Figure A) (Figure B) 5. Reassemble the dash in reverse order of disassembly to complete the installation. REV. 1/7/2022 INST95-7391B...
DESMONTAJE DEL TABLERO PREPARACIÓN DEL KIT 1. Desenganche y quite la mitad superior 1. Corte el área sombreada en el de la cubierta de la columna de dirección subtablero con el fin de hacer espacio y el panel de moldura del tablero de para el radio genérico.
Metra recomienda el uso de adaptadores de acoplamiento adecuados de Metra o de Axxess. Pruebe el radio para asegurarse de que funciona bien. 4. Sujete el ensamble del radio al tablero...