Manuales relacionados para Truper ESMA-4512N
Resumen de contenidos para Truper ESMA-4512N
- Página 1 Manual Angle 1.6 Hp 4 1/2” grinder Power Wheel Applies for: Model Code ESMA-4512N 12873 ESMA-4512N Read this manual thoroughly CAUTION before using the tool.
- Página 2 Contents CAUTION Technical Data Power Requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for angle grinders of fatal injuries please read and understand this Manual before Parts using the tool.
- Página 3 Technical Data ESMA-4512N Code 12873 Description Angle grinder Grinding Wheel 4 1/2” Voltage 127 V Frequency 60 Hz Current 9.5 A Power 1.6 Hp Speed Screwed thread size 11 000 r/min 5/8-11-UNC-1A Duty cycle 50 minutes work per 20 minutes idle.
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for angle grinders This power tool is intended to function as a cutting tool. Read all safety warnings, instructions and specifications provided.Failure to follow the instructions outlined below may result in electric shock, fire and/or serious injury: While operating the grinder CAUTION •...
- Página 6 Safety warnings for angle grinders DANGER KICKBACK (Sharp Recoil) Do not use accessories that are not specifically designed and recommended by the manufacturer. The fact that the Kickback (sharp recoil) is a sudden reaction when a rotating wheel, backrest, brush, or other accessory gets accessory may be installed on the power tool does not ensure safe operation.
- Página 7 Parts Protective Axis Guard Lock Handle Guard Bracket ” grinding Lock Nut wheel included Axis Wrench (Included) Lock Auxiliary Handle Protective Outer Guard Flange Wheel Inner Flange Power Supply Cord Auxiliary Handle Assembling Orifice Guard Bracket Switch Continuous Power cord Carbon Trigger use button...
- Página 8 Preparation Auxiliary Handle Assembly CAUTION Before performing any operation, always make sure that the auxiliary handle is firmly installed. Set the auxiliary handle in one of the three positions according to the operator's preference and the job to perform. Start Up The angle grinder is a manual power tool.
- Página 9 Start Up Useful Tips • To prevent damaging the wheel work using the wheel into the right position. • Press onto the work piece using less force than the tool’s weight to avoid overload and damaging the motor and wheel. •...
- Página 10 Notes ENGLISH...
- Página 11 Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center.
- Página 12 Phone number 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.