Manuales relacionados para Truper ESMA-4580PN
Resumen de contenidos para Truper ESMA-4580PN
- Página 1 Manual 115 mm Paddle Switch 850 W ” Angle Grinder Power Wheel Applies for: Code Model 102496 ESMA-4580PN ESMA-4580PN Read this manual thoroughly CAUTION before using the tool.
- Página 2 Contents CAUTION Technical data Power requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for angle grinders of fatal injuries please read and understand this Manual before Parts using the tool.
- Página 3 Technical Data ESMA-4580PN Code 102496 Description Paddle switch angle grinder Grinding wheel ” Voltage 127 V Frequency 60 Hz Current 6.3 A Power 850 W Speed Thread size 11 000 r/min 5/8-11-UNC-1A Work cycle 50 minutes of work for 20 minutes of rest.
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for angle grinders This power tool is intended to function as a cutting tool. Read all safety warnings, instructions and specifications provided.Failure to follow the instructions outlined below may result in electric shock, fire and/or serious injury: While operating the grinder Select the right disc CAUTION •...
- Página 6 Safety warnings for angle grinders DANGER KICKBACK (Sharp Recoil) Do not use accessories that are not specifically designed and recommended by the manufacturer. The fact that the Kickback (sharp recoil) is a sudden reaction when a accessory may be installed on the power tool does not rotating wheel, backrest, brush, or other accessory gets stuck or snagged.
- Página 7 Parts Lock nut wrench (included) Clamp Protective lever guard Handle Spindle lock ABT-386 (4 ”) Auxiliary grinding wheel included Spindle handle lock Outer flange Wheel Wheel guard Inner flange Ventilation slots Auxiliary handle mounting hole Cable Clamp guard lever Power cord Paddle switch...
- Página 8 Preparation Protection guard mounting 1. Open the clamp lever and match the protruding parts on the inside of the guard protection, push the wheel guard down until the protruding parts engage and rotate freely with the corresponding slots in the shaft cover. 2.
- Página 9 Start up The angle grinder is a hand-held power tool, used to grind and cut steel, pipe, angle iron, brick, tile, stone and/or ceramic pieces; to remove burrs from metal surfaces, to level and smooth welds. Turning On • Connect the plug to the socket. •...
- Página 10 • When changing carbons, always replace both carbons. • For best results, it is recommended to use 4 1/2” inch (115 mm) Truper cutting and /or grinding discs. Storage • Store the tool neatly in a dry place and protected from dust and water.
- Página 11 Authorized service centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center.
- Página 12 06060, where you can also purchase parts, components, consumables and accessories. The costs of transportation of the product that derive from its fulfillment of its service network are included. Truper will not require any proof of purchase to make the warranty effective. Phone number 800-018-7873. Made in China.