Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Air should never be exhausted into the flue which is intended for exhaust of
the smokes emitted from the equipment using gas or other fuels to outside (It may
not be applied for the equipment which only recirculates the air in the room). Flue of
the hood should be only for the hood. It should not be used with equipment in
common
Exit of the hood should not be connected to the air ducts where flues of
other types of equipment are located.
When you connect the hood to the flue, use pipe in diameter of 120 mm.
For good performance, the pipe connection should be as short as possible, smooth
and with minimum bends.
Discharge pipe is not supplied with the product. It should be purchased
separately. Diameter of the discharge pipe should be equal to the diameter of the
connection ring.
As the hood expels the air in the room to the outside, other equipment
operating with air may be affected. For this reason, when the hood operates, allow
entry of fresh air into the house.
In case of use of activated carbon filter without flue connection, never wash
the activated carbon filters. Depending on frequency of use of this filter, you are
recommended to replace it in 2-4 months in average. When you desire to replace it,
please contact with the authorized service centre.
This equipment is market as per the European Directive 2012/19/EC on Waste
Electric and Electronic. If you ensure proper disposal of this product, you will prevent
adverse effects that may arise due to improper treatment of the product for human
health.
The symbol
used on the product itself or on the documents given together with
12
Publicidad
