Publicidad
Idiomas disponibles
Idiomas disponibles
EN
If it is required to replace the lamps, please check the following info and replace it
with an alternative having the same technical specifications.
- ILCOS D code: DBR-1-H (ILCOS d code as per standard IEC 61231)
- LED module – semi-transparent plastic
- Rated power of each lamp: 1W
- Maximum lamp potential power for replacement: 2 x 1W
- Voltage range of the lamp: 220 - 240V
- Product sizes: diameter: 38 mm / height: 26 mm
If required, you may acquire new lamps from the authorized service centre.
Replacement of the Lamps
Prior to replacement of the lamps, remove power cable of the hood. And then lift the
front glass upward and remove the aluminum cartridge filter. Afterwards:
(Figure 12)
(Figure 13)
1. Disconnect the female and male
connectors of the lamps by pushing back
part of the plastic lug as shown in the figure
at left here to release the locking
mechanism. (Figure 12)
2. Hold the lamp at its body and rotate 2
retaining lugs on the lamp clockwise or
anticlockwise to match with the gaps on the
lighting panel. After bringing the retaining lugs
to align with the gaps, hold the lamp at its body
(Figure 13)
and bring it out.
24
Publicidad
