Publicidad
Idiomas disponibles
Idiomas disponibles
Crease & Perforation dies
Crease Die Cleaning
Media being creased may become smeared by toner deposits
accumulating in the groove of the crease die. If this is observed follow
the procedure below to clean the die.
To clean the die:
1.
Complete steps 1-4 from Section 4-A of this manual to remove
the die from the machine. Take care not to damage the chip
located at the rear underside of the die.
2.
Scrape toner residue [3] from the crease die groove [2] using
a plastic pointed swab [1] or similar.
Be careful not to damage the groove of the crease die. Do not
use a metal pointed tip to remove the toner.
3.
Clean excess toner particles [3] from the crease die groove [2]
using a foam or cotton swab [1].
4.
Complete steps 6-9 from Section 4-A of this manual to insert
the crease die into the machine.
5.
Once the die has been inserted, feed some sheets to confirm
that there is no toner marking on the sheet. If toner marking is
still observed complete the cleaning procedure again.
Perforation Die Backing Plate Exchange
It is recommended to exchange the backing plate of the 75-120gsm
die every 250K cycles and the 120-300gsm die every 100K
cycles. Two backing plates are provided with each Perforation die.
Additional backing plate kits can be purchased as service parts.
To exchange the backing plate:
1. Complete steps 1-4 from Section 4-A of this manual to remove
the die from the machine. Take care not to damage the chip
located at the rear underside of the die.
2. Unscrew the 2 knurled screws from the input sheet guide and
remove the input sheet guide.
3. Turn the die onto its side and unscrew the 3 knurled screws from
the underside of the die.
4. Remove the backing plate from the throat of the die. If the backing
plate does not come out easily, push it out from the bottom by
inserting a tool such as an Allen wrench, into the holes provided,
to release it.
5. Slide the new backing plate into the throat of the die and let it fall
into the backing plate opening.
6. Carefully turn the die over and secure the new backing plate
using the 3 knurled screws.
7. Re-attached the input sheet guide and secure the input sheet
guide using the 2 knurled screws.
MFPP-C1
GB
13
Publicidad
