Matco Tools MFJ354PA Instrucciones De Operación página 3

OPERATION
This is the safety alert symbol used for the OPERATING
INSTRUCTIONS section of this manual to alert you to
potential personal injury hazards. Obey all instructions
to avoid possible injury or death. IMPORTANT: Before
attempting to raise any vehicle, check vehicle service
manual for recommended lifting surfaces.
OPERATION:
1. To raise load: Turn the handle in a clockwise direction until tight.
Position the jack under the load. Proceed to pump the handle in order
to raise the lift arm to the load. As the saddle at the end of the lift arm
gets closer to the load, reposition the jack so the saddle will contact
the load firmly and the load is centered on the saddle. Make sure the
saddle is correctly positioned. Raise the load to the desired work height.
Place jack stands of appropriate capacity at the vehicle manufacturers's
recommended support areas that provide stable support for the raised
vehicle. DO NOT CRAWL UNDER VEHICLE WHILE LIFTING VEHICLE
OR PLACING OR REMOVING THE JACK STANDS! Once jack stands
INSTRUCTIONS FOR BLEEDING AIR
Air may become trapped in the hydraulic system during shipping and handling. Trapped air will affect the pumping performance of the jack. If
this occurs, follow the air bleeding procedure below:
STEP 1: Turn the handle to the right until it stops. Pump the handle from its vertical position to its horizontal position
WITHOUT A LOAD to raise the lift arm to maximum height. If the jack raises to maximum height in 4 to 5 pump strokes, it
is ready for use.
If the jack does not go to the maximum height WITHOUT A LOAD in 4 to 5 strokes, follow step 2.
STEP 2:
C
MFJ354PA
MFJ354PA 31/2 Ton Service Jack
2 X
are positioned, turn the handle VERY SLOWLY in a counterclockwise
direction. Lower the load to rest on the jack stands. Inspect the
relationship between the jack stands and load to make sure the setup
is stable and safe. If the setup is not stable or safe, follow the preceding
steps until corrected.
2. To lower load: Follow the procedures mentioned in "To raise load"
section of the OPERATING INSTRUCTIONS in order to raise the load off
the jack stands. Once the load has cleared the jack stands, remove
the stands from under the load and away from the work area. DO
NOT CRAWL UNDER VEHICLE WHILE LIFTING VEHICLE OR PLACING
OR REMOVING THE JACK STANDS! Turn handle very slowly in a
counterclockwise direction until the load is completely lowered to the
ground. Once the jack's lifting saddle has cleared the load, remove the
jack from under the load.
CAUTION: Keep hands and feet away from the hinge mechanism of
the jack.
15 X
D
3 rev. 04/05/21