Fermax DUOX PLUS VEO Guía Inicio Rápida página 5

START GUIDE FOR MONITOR VEO DUOX PLUS
CONTROL BUTTONS
Inductive loop
label (depending on the model)
F2
The white line at the bottom of the icon indicates the function that is currently in effect.
Select with
CONFIGURING AS MASTER PANEL
Press the SW1 button 3 consecutive times quickly. After 2 seconds, a confi rmation tone is heard, and
the master panel is activated. Once having completed the monitor´s programming, we recommend
deactivate the MASTER panel by pressing the SW1 button 3 consecutive times.
HOW TO PROGRAM THE VEO MONITOR
1. INSTALL
Monitor powered for the fi rst time.
The red led blinking rapidly indicates that the monitor has not been
programmed. The fi xed red led indicates that the monitor has been
programmed.
2. ENTER PROGRAMMING MENU
Press the button to access the "programming menu."
PROGRAMMING FROM THE PANEL
PROGRAMMING MENU
Select the
Enter the calling code for this monitor from the panel (calling code for this monitor). A different
call tone sounds, confi rming the monitor´s programming. After a few seconds the monitor returns
to standby.
2
DUOX PLUS VEO MONITOR
Digital menu for internal parameter settings and confi guration.
(When the monitor has already been programmed)
In conversation, press to open the door.
In standby, call to guard unit (if applicable).
Auxiliary function, (contact your installer).
In standby, press and it displays the option of auto-on with
different panels. By sequentially pressing Panel 0, Panel 1,
General Panel, (depending on the available panels).
VEO monitor incorporates an OSD menu that is managed via the
99
monitor´s push buttons. The icons displayed are managed with
the corresponding buttons located on the monitor.
/ the desired icon and confi rm with
icon and confi rm with
.
, (you hear a beep in the monitor).
Code 970160 V03_20