Publicidad
CAUTION
• Before installing or operating the
equipment, disconnect from any power source to avoid
electric shock and/or burns due to short circuits.
• Do not touch the bare (unprotected)
CAUTION
terminal. An electric shock will result.
• Do not touch any live lines simultaneously,
CAUTION
an electric shock will result.
• Do not install or handle equipment without
CAUTION
proper protective equipment or with wet hands.
• Do not install, connect, disconnect or handle the equipment
under load. With the exception of socket outlets, never
connect pluggable equipment when it is energized.
• If you do not have or doubt that you have the appropriate
technical knowledge, never install or handle the equipment.
• Before installation, be sure to read these operating
instructions carefully to ensure correct operation.
• Installation, maintenance and inspection of
CAUTION
electrical equipment must be carried out by qualified
technicians with special knowledge.
• Do not install the equipment in an environment with shock,
high temperature, humidity, dust, corrosive gases, excessive
vibration, etc. to avoid fire accidents and/or equipment
malfunction.
• Use electrical equipment with the voltage and current ratings
shown on the nameplate, otherwise it may cause
malfunctions and even dangerous situations.
Shaft
key
Shaft
Ventilation
slots
6
ENGLISH
Base with
fixing holes
Ventilation
slots
Safety warnings
for electric motors
• Tighten the terminal screws to the proper torque to prevent
overheating.
• Make sure that the equipment and the connection cables
are securely fastened.
• Always use terminals on the cables to which the equipment
is connected, these must be suitable for the load to be
supported.
• If there are several terminals in close proximity, each
terminal or conductor pole must be connected in parallel.
• If the equipment is equipped with grounding terminals,
make sure they are grounded.
• Always connect the equipment according to the indications
and diagrams provided by the manufacturer.
• Never exceed the operating ranges indicated by the
manufacturer.
• Do not modify the equipment.
• When the equipment is to be disposed of, it should be
disposed of as industrial waste.
• Do not connect aluminum terminals and conductors to the
switch directly.
• Always comply with the regulations in force at the place of
installation.
Parts
Connection
panel cover
Power cord
Cable outlet
inlet
to ground
Starting and
working
capacitors
Name
plate
Publicidad
