Husqvarna Automower EPOS Plug-in Kit Manual De Usuario página 112

start to operate. You must do a pairing operation of
the product and the Automower
objects on the map, change the settings and operate
the product. Use the Automower
mobile device or on the app.
1. Set the product to ON.
Note:
®
The Bluetooth
of the product is enabled for 3 minutes. If the
pairing operation between the product and the
mobile device is not completed in 3 minutes, set
the product to OFF and then set the product to ON.
2. Log on to your Husqvarna account in the
Automower ® Connect app.
®
3. Start Bluetooth on your mobile device.
My mowers in the Automower
4. Select
app and add your product.
5. Enter the factory PIN code.
6. Follow instructions for the EPOS
®
Automower Connect app. Do a paring operation
with the reference station and the charging station
and install the map objects.
Note:
It is only necessary to do a pairing operation of
®
the Automower Connect app and the product one time.
®
39.10.4 Automower Connect
®
Automower Connect is a free app for your mobile
device. Use the app for installation, settings and
operation of your product. You can also find more
information for example about alarm and statistics in the
®
Automower Connect app.
The app gives 2 modes of connectivity: Long-
range cellular connectivity and Short-range Bluetooth
connectivity.
• Dashboard that shows the current status of the
product and the battery state of charge.
Note:
All countries do not support cellular connection
®
to Automower Connect because of regional specified
cellular systems. The included Automower
lifetime service only applies if there is a third part sub-
supplier of available in the operational area.
39.10.5 Installation of the charging station
Read and understand the instructions about the
To examine where to put the
charging station. Refer to
charging station on page 107 .
CAUTION:
Do not make new holes in
the charging station plate.
112 - Installation
® Connect app to install
®
Connect app on your
pairing operation mode
®
Connect
™
setup in the
®
®
Connect
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When you connect the power supply, only use a power
outlet that is connected to a residual-current device
(RCD).
39.10.5.1 To install the charging station
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1. Read and understand the instructions about the
charging station. Refer to
the charging station on page 107 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
installed.
3. Open the hatch on the front of the charging station.
4. Attach the top of the charging station.
Make sure that the plugs of
Make sure that the plugs of
To examine where to put
1944 - 001 - 13.01.2023