Husqvarna Automower EPOS Plug-in Kit Manual De Usuario página 118

Note:
The position of the waypoint when you install a
transport path or a path to a maintenance point is in the
middle of the product between the drive wheels.
• Make sure that you are near the product and
connected to the product with the app with
Bluetooth ® .
• Make sure that the status is
the appDrive.
• Select the object you want to install and use the
buttons in the appDrive installation to operate the
product.
• Use the up button (A) to move the product forward.
• Use the down button (B) to move the product
rearward.
• Use the left arrow button (C) to rotate the product
to the left.
• Use the right arrow button (D) to rotate the product
to the right.
• Use the center button (E) as a joystick to move and
rotate the product in any direction.
• Use the waypoint button (F) to add a waypoint in
the map.
• Use the undo button (G) to remove the latest
waypoint.
A
E
C
B
Note:
Walk 2-3 m / 6.5-9.8 ft. behind the product
when you operate the product with appDrive.
118 - Installation
EPOS ™ confirmed in
G
D F
To make a work area
Minimum 3 waypoints are necessary to make a work
area.
• Operate the product clockwise around the
boundary of the work area.
• Add waypoints on the map. Add the waypoints
minimum 3 cm / 1 in. from obstacles.
• Add a waypoint to make the product cut the grass
at the edge between the lawn and the stone path.
Make sure that you straddel the edge of the lawn
and the stone path when you add a waypoint. The
product can straddel the edge if the height of the
stone path is maximum 1 cm / 0.4 in. in relation to
the lawn.
•
max 1 cm / 0.4"
• Add the waypoint at the outer corner to install the
virtual boundary around a corner.
1944 - 001 - 13.01.2023