Chicco Next2me Magic EVO Manual Del Usuario página 18

steps described in the paragraph about "REMOVING THE COV-
ER". Subsequently:
32. Take hold of the crib frame "E" and rotate the crib base "E4"
inwards by 90°. Repeat the same operation for the upper
frame "E1" (Fig. 36).
33. Remove the central support "D" from the fittings "A4" found
on both legs by pushing on the metal pins and pulling up-
wards (Fig. 37).
34. Remove the bottom bar "C" from its fitting "A5", pressing on
the metal pin (Fig. 38). Repeat the same step for the other
leg as well.
35. Remove the feet "B" by pressing on the metal pins and pull-
ing them free from the leg supports (Fig. 39).
36. Place all the disassembled components in the bag "I".
WARRANTY
The product is guaranteed against any lack of conformity under
normal use as specified in the instructions. The warranty shall
not therefore apply in the case of damage caused by improper
use, wear or accidental events. For the duration of the warran-
ty on conformity defects please refer to the specific provisions
of applicable national laws in the country of purchase, where
appropriate.
18