TDK-Lambda ZWX Serie Manual De Instrucciones página 16

ZWX240
②
CN1
①
②
① Input Terminal : CN1(Refer to 2-2.)
② Mounting hole : hole diameter : φ3.5mm
This hole is connected to Protective Earth of CN1.
Must be connected to electrically conductive spacer.
The mounting surface of the spacer should be within Maxφ8mm.
③ Output Terminal : CN21（+3.3V, +5V and -12V）(Refer to 2-3.)
④ Output Terminal : CN31（+3.3V, +5V, +12V, -12V, 5V SB and +3.3Vsense）(Refer to 2-3.)
⑤ Signal Terminal : CN41（PS_ON and PWR_OK）(Refer to 2-3.)
ZWX300
②
CN1
①
②
① Input Terminal : CN1 (Refer to 2-2.)
② Mounting hole : hole diameter : φ3.5mm
This hole is connected to Protective Earth of CN1.
Must be connected to electrically conductive spacer.
The mounting surface of the spacer should be within Maxφ8mm.
③ Output Terminal : CN21（+3.3V, +5V and +12V-1）(Refer to 2-3.)
④ Output Terminal : CN31（+3.3V, +5V, +12V-1, -12V, 5V SB and +3.3Vsense）(Refer to 2-3.)
⑤ Signal Terminal : CN41（PS_ON and PWR_OK）(Refer to 2-3.)
⑥ Output Terminal : CN51（+12V-2）(Refer to 2-3.)
T3
T2
T3
T2
-3-
TDK-Lambda
ＺＷＸ Series
Instruction Manual
②
CN41
⑤
④
CN31
CN21
③
②
CN41 ⑤
CN31
④
CN21
③
CN51
⑥
②
②