Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The trolley must be completely removed from its packaging.
All guards must be completely removed.
Place the cart on a solid, flat surface. Never put the display on a flammable surface.
Do not install near open fires or other heating devices.
The electrical cable must be protected to at least 16 Amps. The plug should be plugged directly into a wall
outlet. Using a power strip will trip the device. *
Mount the protective glass in the locations provided for this purpose. Position the accessories in their intended
locations.
* Electrical connection: the installation and commissioning of the device must be entrusted to personnel with
the necessary skills for this purpose and carried out in compliance with the standards in force in terms of
accident prevention. Be sure to make the connection in accordance with the data given on the technical
characteristics plate. Power outlets should be near the device and easily accessible.
Switch off and unplug the appliance, then use hot soapy water to clean the stainless steel plates.
NEVER use cold water on the stainless steel plates because you risk causing a thermal shock.
FRYER USE
Check that there is no water in the oil pan then pour oil into the pan. Two marks are inscribed in the oil tank.
Minimum and maximum quantities must be respected. It is recommended to use a quality oil, vegetable oils
less saturated with fats are recommended. (When using solid shortening, always melt it before adding it to
the frypot)
Plug in the device once the oil tank has been filled up to the mark.
Once plugged in, the red indicator light comes on.
Turn the thermostat to the desired temperature. The green light will come on, then go off once the desired
temperature has been reached.
Once the frying is done, hang the basket to drain it.
Do not close the lid until the oil or fat has cooled.
When the temperature drops, the unit starts heating again to keep the oil at the desired temperature, the
temperature light will automatically turn on again.
Change the oil regularly. After the fryer and the oil have cooled, carefully pour the used oil into the collection
container and dispose of it in accordance with the rules of environmental protection.
USE PLAQIE A SNACKER
EN
Publicidad
