Probuilder 49008 Manual De Instrucciones página 51

General warning about vibrations
WARNING! The actual vibration emission
value when using the power tool may
be diff erent from the value stated in the
instructions or on the manufacturer's
website. This may be due to the following
factors, which you should be aware of during
use:
• Is the power tool being used correctly?
• Is the power tool being used on the
correct material?
• Is the power tool in a good, fault-free
condition?
• Are any handles or vibration-dampening
devices properly attached to the power
tool?
If you experience tingling and numbness in
your � ngers, or your hands become pale and
feel cold when using the power tool, stop
work immediately. Take suffi ciently long work
breaks. If you do not take suffi ciently long
work breaks, you risk developing hand/arm
vibration syndrome.
Assess the degree of strain from the work or
use of the power tool, and take appropriate
work breaks. This can reduce the degree
of strain from the total working time
signi� cantly Reduce the risk that vibrations
expose you to. Maintain the power tool as
described in the instructions. If you use the
power tool frequently, you should contact
the retailer and obtain relevant anti-vibration
accessories (such as an anti-vibration
handle).
Do not use the power tool at temperatures
of 10 °C or below. Draw up a work plan that
ensures that the exposure to vibrations is
limited.
General warning about noise
WARNING! A certain noise level from this
power tool is unavoidable. Carry out noisy
work at times when this is permitted and
will cause the least possible inconvenience.
In order to protect your hearing, you and
people in the vicinity are recommended to
use suitable hearing protection.
Special safety instructions
This wall and ceiling sander is only designed
for surface sanding of rendered walls and
ceilings and wooden or plaster walls and
ceilings.
Always use a dust mask and, where
appropriate, safety goggles when using the
wall and ceiling sander.
Keep the cord well clear of the working area.
Do not put the sander down until it has
completely stopped.
Be aware that static electricity may form
when using the wall and ceiling sander.
Avoid running the sanding head over nails,
screws or other jutting objects on the
surface, as this may cause damage to the wall
and ceiling sander.
GB
51