Publicidad
ASSEMBLY INSTRUCTIONS
Align the arrow on the base assembly
(which is near the central hole of the
base assembly ) with the arrow on the
rear of the tower fan unit and push the
base assembly close to the tower fan
unit tightly.Firmly hold the fan body
steady and rotate the base assembly
clockwise until three plastic hooks on
the tower fan bottom lock unto the three
open slots of the base assembly tightly.
You should now notice that the
hexagonal screw hole on the base
assembly is aligned with the screw hole
on the bottom of the tower fan unit.
( Fig. 4 )
Insert and tighten the hand screw (A)
into the hexagonal screw hole to
secure the base assembly to the tower
fan unit. ( Fig. 5 )
4. Securing the Power Cord to the
Base Assembly
With the fan still on its side, locate the
power cord holding bracket at the
bottom of the base assembly. Gently
pull any slack out of the power cord,
place the power cord securely in the
holding bracket and secure the power
cord bracket over the power cord. Then
thread the power cord through the "U"
locating notch on the edge of the base
assembly. ( Fig. 6 )
Return the tower fan to its upright
position.
Note: Do not operate the tower fan unless it is
in its proper, upright position.
4
5
6
A
Publicidad
