Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION & OPERATION
4.
Hold the pipe, remove pipe clamp and slide well seal over
rigid PVC pipe and onto well casing. Position assembly so
that twelve inches of rigid PVC pipe protrude from well seal.
Alternately turn bolts on well seal clockwise until rubber
gaskets are tight against well casing and rigid PVC pipe.
FROM WELL SEAL
WELL SEAL
7083 0716
5.
Cement 1-1/2" PVC elbow onto rigid PVC pipe protruding
from well seal. If desired, some length may be cut off of
rigid PVC pipe before cementing elbow. Use a round file or
knife to smooth the inside of any rigid PVC pipe that has
been cut.
6.
Thread a 1-1/2" male PVC adapter into the front of pump.
Hand tighten, then turn 1/4 turn with wrench.
1-1/2" PVC PIPE
7086 0716
7.
Cement as many sections and couplings of PVC pipe needed
to connect the PVC elbow to the 1-1/2" male PVC adapter in
the front of the pump.
7087 0716
8.
Using pipe wrench, thread 1-1/2" discharge tee into top of
pump. Remove 1-1/2" plug from top of discharge tee. Put a
garden hose into top of discharge tee. Fill pipes and pump
until water overflows from top of discharge tee. This may
take several minutes.
FP1001 (02-01-2023)
APPROX.12"
OF PVC PIPE
PROTRUDING
1-1/2"
DISCHARGE
TEE
9.
Thread the 1-1/2" pipe plug back into the top of discharge
tee.
7088 0716
10. Complete all electrical connections as specified earlier in
manual.
11. Place a large bucket beneath discharge tee outlet. Start
motor. If pump is offset from well 4 feet or more, it may
take a few minutes for pump to prime. Failure to prime in 5
minutes: Stop motor, remove 1-1/2" plug from discharge tee,
add more water, try again.
12. Allow pump to run long enough to clear well of sediment
and to insure well will not run dry. Stop motor. Thread 1-1/2"
make PVC adapter into discharge tee outlet.
13. Cement as many PVC pipe sections and couplings needed
to connect the 1-1/2" male PVC adapter to inground
sprinkler system. Complete installation should look like
the figure below.
COMPLETE
SHALLOW WELL
INSTALLATION
1-1/2"
PIPE
PLUG
7
Publicidad
