Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
10. Adjust floor levelers to level the unit against the wall
where desired. Using back stretcher (E) as a template, mark
one mounting holes location on the wall. Drill one pilot holes
into the wall where previously marked. Make sure that the
drilled holes can fit for the wall anchors (sold separately)
properly. Press the anchors into the holes and gently tap
with a hammer until flush in the holes. If the mounting hole
coincides with a wooden stud, there is no need wall anchor.
Align back stretcher (E) and back crossers (NN) over the
drywall anchors (MM) and secure with M5 x 65 mm screw
(OO). Tighten securely with phillips screwdriver.
Plug Plastic Covers (II) to cover the small cam locks for nice
looking.
NOTE: Must install for both base and stacker.
Hardware Used
M5 x 65 mm
OO
Screw
Plastic Cover
II
MM
Drywall Anchor
Back Crosser
NN
11. Drawer installation
1a. Extend the ball bearing slide tracks on the unit all
the way forward (including ball bearing cart).
1b. Align the slide runners on the assembled drawers
with the slide tracks and push the drawer carefully
inside until it stops.
NOTE: If the drawer does not go in smoothly, please take it
out and repeat the step. If you need to remove the drawer,
please pull the drawer all the way out, then simultaneously
pushes the plastic release lever of the ball bearing slides
up on one side and down on the other side, and then pull it
completely out.
10
Wall
MM
NN
E
OO
x 1
x 4
x 1
x 1
11
Ball bearing cart
9
ASSEMBLY INSTRUCTIONS
12. This cabinet was designed with a feature that allows
stacking two units. Additional units sold separately. Insert
wood dowels (CC) into the holes on top of the base unit.
Place bottom of second unit onto the inserted dowels.
Secure units together by attaching the metal plates (EE)
at both ends with the M3.5 x 19 mm screws (JJ) into the
predrilled holes.
If you plan to use this unit as hutch (stand this on anoth-
er one), please skip step 9 &13.
II
NOTE: Remove caps (HH) before stacking two units
together.
Hardware Used
CC
Wood Dowel
EE
Metal Plate
JJ
M3.5 x 19 mm Screw
13. Insert the caps (HH) into the holes on top of the top
panel (A).
Hardware Used
HH
Cap
12
CC
x 4
x 1
x 4
13
x 4
10
JJ
EE
HH
Publicidad
