Publicidad
Micronics
system changing configuration while operating in local mode, set Block
All Remote Changes, or Block Remote Total Changes as
appropriate, in the Modbus Setup menu. Blocking all remote changes
includes blocking of total changes.
When complete select Save, Configure and Exit.
13.1
Supported Messages
The following message types are supported from the Modbus
Application Protocol Specification:
Message Type
READ HOLDING REGISTERS
WRITE SINGLE REGISTER
WRITE MULTIPLE
REGISTERS
Issue 1.1 March 2022
Message
Number
03 (0x03)
06 (0x06)
16 (0x10)
Notes
Read a contiguous block of
registers.
Write to a single register.
Write to multiple registers in
one transaction.
Page 5
Publicidad
