Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
6.
Push and position the rib of the inner side
of the track in the groove of the rear wheel.
If needed, turn the wheel gently to help with
installation.
Figure 33. Push the Track into Place on the Wheel
7.
Work the track onto the rear wheel and verify
the rib of the track is positioned properly
within the groove of the wheel.
8.
Push and position the rib of the inner side
of the track in the groove of the rear wheel.
If needed, turn the wheel gently to help with
installation.
Section 7. Troubleshooting
Information about the cleaner status and any relevant condition will be displayed in the iAquaLink
while the cleaner is on the charging station.
7.1
General Troubleshooting
The following list provides some helpful hints for troubleshooting common challenges when using the
cleaner.
User Issue
The cleaner does not
stay on the pool surface
or is floating excessively.
The cleaner is not
climbing walls.
Page 18
Possible Cause
There is air trapped inside
the cleaner housing.
The filter canister is full or
dirty.
The filter canister is full or
dirty.
Track treads worn down.
Confirm appropriate pool
chemistry.
Product in Floor Only mode.
Polaris
FREEDOM
®
™
6.6
Spare Parts
The complete spare parts list and exploded view is
available on the Polaris website.
• USA: polarispool.com
• Canada: polarispool.ca
Contact your local maintenance provider to
perform diagnostic tests or repairs not shown in
general maintenance.
6.7
Recycling & Disposal
The battery is not a serviceable or replaceable
component. DO NOT attempt to service the
battery.
Battery and cleaner must be disposed of in
accordance with local requirements.
Always dispose of batteries in a sustainable way in
approved collection bins or at authorized collection
centers in accordance with local law. Contact your
local authority for more information.
Suggested Solution
Remove cleaner from pool and re-submerge (see Install
and Submerge the Cleaner).
Dispose of debris and thoroughly clean the filter
canister with mild soap and a soft brush. Then, re-
submerge the cleaner (see Clean the Filter Canister).
Dispose of debris and thoroughly clean the filter
canister with mild soap and a soft brush. Then, re-
submerge the cleaner (see Clean the Filter Canister).
See Replacing Wear Parts.
Speak with your pool service professional. Do not leave
cleaner in the pool during any chemical treatments.
Select Floor/Wall cleaning mode.
Cordless Robotic Cleaner | Owner's Manual
app
®
Publicidad
