Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
FREEDOM
Cordless Robotic Cleaner | Owner's Manual
®
™
This device complies with Part 15 of the FCC Rules and IC licence-exempt RSS standard. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception which can be
determined by turning the equipment off and on, the user is encouraged to try to correct interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the part responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This device complies with FCC and IC RF radiation exposure limits set forth for general population. This
device must be installed to provide a separation distance of at least 20cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
ISED Canada Regulatory Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two
conditions:
1.
This device may not cause interference.
2.
This device must accept any interference, including interference that may cause undesired operation
of the device.
FCC Statement
CAUTION
SAVE THESE INSTRUCTIONS
ENGLISH
Page 3
Publicidad
