Federal Signal ICSSPL-P Serie Manual De Instrucciones página 2

Installing the ICON Series ICSSPL-P Snow Plow Headlight
Installing the Work Light
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in the deployment path of an
airbag. Failure to observe this warning will reduce the effectiveness of the airbag or potentially
dislodge the equipment, causing serious injury or death.
To prepare for the installation:
• Ensure that the battery voltage is the same as the voltage rating of the plow headlight.
• Determine where to mount the plow headlight on the vehicle.
• Decide where to route wiring for the plow headlight.
To install the work light:
1. Determine the mounting location for the light and the installer-supplied control system.
DRILLING PRECAUTIONS: When drilling holes, check the area you are drilling into to ensure
that you do not damage vehicle components. All drilled holes should be deburred, and all sharp
edges should be smoothed. All wire routings going through drilled holes should be protected by
a grommet or convolute/split loom tubing.
2. Drill two 12-millimeter (15/32-inch) holes at the mounting locations for the mounting bolts. Use the
supplied hardware to secure the headlights to the vehicle as shown in Figure 1.
2
Table 1 Kit Contents
Qty Description
2 Stainless Steel Post Bracket, Black
2 Rubber Mounting Gasket for Post Bracket, Black
4 Stainless Steel Post Base, Black
4 Rubber Mounting Gasket for Post Base, Black
4 Stainless Steel Domed Friction Washer
4 Stainless Steel Screw, M12 1.75 X 45 mm
4 Stainless Steel Washer, for M12
4 Stainless Steel Lockwasher, for M12
4 Stainless Steel Nut, M12 1.75
4 Stainless Steel Screw, M8 1.25 X 25 mm
4 Stainless Steel Washer, for M8
4 Stainless Steel Lockwasher, for M8
ICON Series ICSSPL-P Snow Plow Headlight
Federal Signal worktruck.fedsig.com