Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the ICON Series ICSSPL-P Snow Plow Headlight
4. Route wire from the control system to the location of the plow headlight. Refer to Table 2 for
minimum wire gauges for each wire/function of the plow headlight.
5. Route a 16 AWG wire from the installation area of the light to an appropriate ground.
LIGHT HAZARD: A plow headlight produces bright light that can be hazardous to your eyesight
when viewed at a close range. Do not stare directly into the lights at a close range, or permanent
damage to your eyesight may occur.
6. Check the wiring and test the light for proper operation.
Aiming the Headlight
FEDERAL REGULATIONS: The installer of these snowplow headlights must certify that
installation conforms to applicable Federal Motor Vehicle Safety Standards as well as relevant
state and local laws. The headlights must be inspected for conformance if they are ever shifted/
adjusted.
After the headlight has been mounted and the electrical connections have been secured and tested, the
headlight will need to be aimed to comply with appropriate federal, state, and local standards.
1. Park the vehicle on a level surface so that the headlights are 25 feet in front of a flat, matte-white
surface, such as a wall or garage door. The surface should be perpendicular to both the ground and
to the vehicle center line.
2. The vehicle should be equipped for typical operation. The snow plow blade should be in place and in
the raised position.
3. The notes listed below are recommended for inspection by the Society of Automotive Engineers
(SAE) prior to setting or adjusting the headlight aim:
• Remove ice or mud from under the fenders.
• Set tire inflation pressures to the values specified on the vehicle information label.
• Check the vehicle springs for sag or broken leaves.
• Verify that there is no load in the vehicle other than the driver and spare tire kit.
• Check the functioning of any automatic vehicle leveling systems.
• Clean the head lamp lenses and check for the burnout of any light sources.
• Stabilize the suspension by rocking the vehicle sideways.
4. Verify that the headlight is at least 22 inches above the ground and not more than 54 inches above
the ground.
5. Mark or tape the vertical center line of the ICSSPL-P headlights and the vertical center line of the
vehicle on the white surface. Mark the horizontal center line of the headlights on the surface as well.
These markings should be measured from the physical headlights, not the light emitted from the
headlights.
4
ICON Series ICSSPL-P Snow Plow Headlight
Federal Signal worktruck.fedsig.com
Publicidad
