N'oveen PTC2000 SMART Manual De Instrucciones página 11

21. Do not use outdoors. FOR INDOOR USE ONLY.
22. Do not leave the appliance unattended when switched on.
23. Do not place objects on the product or allow objects to obstruct the inlet or outlet openings, or
operate in close proximity to walls or curtains, etc. Do not cover the unit when in operation.
24. Do not locate the heater immediately below a socket-outlet.
25. The use of attachments or accessories not recommended or sold by the product distributor may
cause personal or property hazards or injuries.
Use this heater as described in this manual. Any other uses, not recommended by the manufacturer,
may cause fire, electric shock, or injury to persons and may void the warranty.
USING THE PTC2000 HEATER See Picture 1
1. Before inserting the plug into an electrical outlet, make sure the electrical supply in your
area matches that on the rating plate of the device.
2. After connecting, turn on the main power switch (1) on the back of the device.
3. In standby mode, press (2) on the control panel, the LED display will show the room temperature.
Press the (2) button to access the rest of the control panel.
(a) Low power: 1400W (press (3) to turn on, one indicator on)
(b) High power: 2000W (press (3) to turn on, two indicators on)
(c) TIMER: Press the (4) button several times to set the time after which the heater will turn off (from
0 up to 8 hours)
(d) Room temperature control. Temperature setting is in the range of 10-49 . ℃
Press (6) to increase the desired temperature or (7) to lower the temperature. When the room
℃
temperature is 4 lower than the set temperature, the device operates at high power. If
℃
the temperature is 2 lower, the appliance operates at low power. If the room temperature
reaches the set temperature, heating stops, the fan remains on until room temperature will be 2 ℃
lower than set. The device automatically returns to low-power heating. If the room temperature is 4 ℃
lower than the room temperature, the appliance will automatically start high-power heating.
(e) Oscillation: Press (5) to activate automatic oscillation. Press the button again to
cancel.
(f) Press (2) to turn off the heater, the unit will blow cool for 30 seconds after shutdown for protection.
USING THE PTC3000 HEATER See Picture 2
1. Connect the plug to a wall socket.
2. Turn on the main switch on the back.
3. The device beeps (if the sound is on).
4. Press the (1) button to turn on the device. The device will turn on with the fan working.
11