Publicidad
Idiomas disponibles
Idiomas disponibles
7
Using the 24 mm fixed spanner and the tubular socket wrench, screw the top nuts as shown in the following
image to lock them. Spray the rubberised surface of the rollers to clean it with water, preferably hot. IMPORTANT:
The equipment must be stopped and disconnected before handling it in any way.
8
Use an Allen key Nº 5 to unscrew the four bottom
bolts and washers that hold the liquid collector.
Remove it from the machine and clean it.
10
Finally spray and clean with water, preferably hot, the rest of the machine as well as the components in
general. It is important to pay special attention and safeguard the following components from water:
• Electrical components: Motors, sensors
• Control panel
• Bearings
Take the opportunity to check that all components are in good condition.
11
Once the cleaning process is completed, and the equipment is completely dry, reverse the above steps to
reassembly of the equipment.
27
Imagen (1)
9
Use an Allen key Nº 4 to unscrew the two bolts and
washers that hold the rollers rear protection.
Remove it from the machine and clean it.
Imagen (2)
Publicidad
