Publicidad
Idiomas disponibles
Idiomas disponibles
Programming the personalized radio code
The installation radio code is coded by programming
Use the personalised radio code selected for the
G
control panel.
Key presses
Personalised radio code
Remote control code
On the "remote control code" line sketch beneath each
cross the symbol
corresponding to the "Off" button.
Complete the empty slots by sketching the
G
bol corresponding to the Total Arm button.
You now have a series of
ponding to the programming code.
1
2
3
4
5
6
7
8
and
symbols corres-
Program the radio code by pressing the keys on the
G
detector as indicated below:
9 10
1. Start
programming
by pressing
both keys
simultaneously
until the indicator
light goes out
sym-
If you make a mistake, the red indicator light will
flash. Repeat the procedure from the beginning.
23
. . .
2. Enter the
3. Confirm the
sequence
programming
of 10 short key
by pressing both keys
presses
simultaneously until the
corresponding to
indicator light goes out.
the personalised
The indicator light will
radio code
come on for 5 secondes
to indicate the
programming has been
successful
GB
Publicidad
