LOGISTY L2612 Manual Del Usuario página 25

Selecting programmable options
For programming the key Prog., carry out the follo-
G
wing sequence:
. . .
1. Start 2. Enter the
programming sequence
by pressing of 8 short key
both keys presses
simultaneously corresponding
until the to the selected
indicator light function
goes out
If you make a mistake, the red indicator light will
flash. Repeat the procedure from the beginning.
3. Start 4. Press
programming the Prog. key.
by pressing The light then
both keys comes on again
simultaneously for 5 seconds to
until the indicate
indicator light successful
goes out programming
Coding the Prog. key:
You can allocate one of the functions described below
to the Prog. key.
The symbol represents a press of the "Off" key.
The symbol represents a press of the "Total arm"
key.
Function
Alert call
Silent alarm
Audible signal
Light
Stay arm
Gate "0"
Gate "1"
Example, for programming the key
G
function, carry out the following sequence:
25
.
Coding the Prog. key
on the light
GB