Publicidad
Idiomas disponibles
Idiomas disponibles
SMARTKOM
Both in Android or in OS, the control and configuration of the device is done by using the following interfaces:
1
Connection ASuite- SmartKom
2
Read SmartKom Configuration
3
Send configuration to SmartKom
4
Adjusting and balancing of channels
5
Save configuration
6
Open stored configuration
7
Option menu
8
Antennas power control
1. Connection ASuite - SmartKom: The connection between ASuite and SmartKom is achieved via the Bluetooth interface
enabled in the power supply.
(Note). Bluetooth interface is enabled during the first two hours once the Power supply is turned on, after which it is disabled to mi-
nimize power consumption. To re-enable, it is necessary to power –cycle the unit.
2. Read SmartKom Configuration: ASuite reads the configuration (channels, power, programmed output level) of SmartKom.
3. Send configuration to SmartKom: ASuite sends the configuration chosen by the user (channels, power, programmed out-
put level) to SmartKom.
(Note). The ASuite configuration changes do not mirror automatically in the SmartKom. The user must send the selected configura-
tion to the device using this button.
4. Adjusting and balancing of channels: The adjustment and balancing of the SmartKom channels is activated. This is equiva-
lent to the "short press (< 3 sec) which is done either in the SmartKom or in the PSU.
5. Save configuration: SmarKom configuration is stored in the memory of the device (Smartphone or similar) which was used
to programs it.
6. Open stored configuration: A previously stored configuration may be retrieved from memory.
7. Option menu: Shows all available options in the App.
8. Antennas power control: 3 different power modes can be selected on each input: AUTO/ON/OFF
Figure 10: VHF + UHF1 screen
9
Scroll to open screen of channel balancing
10
Channels found in input 3
11
Channels found in input 2
12
Channels found in input 1
13
Output level adjusting (dBmV)
14
Input 3
15
Input 2
16
Input 1
Figure 9: Select Device screen.
12 volts is generated in the selected input
ON
to power the antennas
No voltage is generated in the antenna
OFF
input
SmartKom generates 12 volts if required
AUTO
in the algorithm/process of automatic
channel search
10
Publicidad
