Televes SMARTKOM Manual De Instrucciones página 4

SMARTKOM
1. SAFETY INSTRUCTIONS
Safe installation
- Read these instructions before handling or connecting the equipment. Keep
these instructions. Heed all warnings. Follow all instructions.
- Clean only with dry cloth.
- Do not use this apparatus near water. Apparatus shall not be exposed to
dripping or splashing and no objects filled with liquids, such as glasses, shall
be placed on the apparatus.
- Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions. Please allow air circulation around the equipment.
- Do not place the equipment in a highly humid environment.
- Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat. Do not place naked
flames, such as lighted candles on or near the product.
- Do not place the equipment in a place where it can suffer vibrations or shocks.
- Only use attachments/accessories specified by the manufacturer.
Safe operation of equipment connected to the mains supply
- Ambient temperature should not be higher than 113°F.
- Power requirements for this power supply are: 110-120V~ 50/60Hz.
- It is strongly recommended not to connect the power supply to the mains
supply until all connections have been done.
- The socket outlet shall be installed near the equipment and shall be easily
accessible.
- To disconnect the power supply from the mains supply pull the plug never the
cable.
- Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
- Unplug this apparatus during lightning storms or when unused for long
periods of time.
2. DESCRIPTION OF CONNECTIONS AND CONTROLS
Smartkom mast amplifier - Ref. 531980
100% DESIGNED, DEVELOPED & MANUFACTURED IN TELEVES CORPORATION
ON
ADJUST SCAN
1
TV
12V
750mA
3
1. LED power on / Adjust / Scan
2. Readjust / Autoscan button
3. Output
4. Input 3 VHF low/VHF high/UHF
5. Input 2 VHF low/VHF high/UHF
6. Input 1 VHF low/VHF high/UHF
READJUST
AUTOSCAN (+5 sec.)
2
Download ASuite
VHF (h/l) + UHF
3 2 1
12V 12V 12V
70mA 70mA 70mA
5 6
4
SCAN
ADJUST
ON
: ON : Fast blink
- Refer all servicing to qualified service personnel. Servicing is required when the
apparatus or power supply have been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into them,
the apparatus or power supply have been exposed to rain or moisture, do not
operate normally, or they have been dropped.
Warning
- Reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture.
- Do not take the cover off the equipment without disconnecting it from the mains
supply.
- This apparatus must be securely attached to the floor/wall in accordance with the
installation instructions. Do not connect the equipment to the mains supply until
it is screwed to the wall.
Symbology
Power supply equipment designed for indoor use.
This symbol indicates that the power supply complies with the safety
requirements for class II equipment.
The present product can not be treated as normal household waste,
it must be delivered to the corresponding collection point for waste
electrical and electronic equipment (WEEE).
Power supply unit - Ref. 550280
5
INDICATIONS - LED
Searching for channels
Adjusting
Switched on
: Slow blink
1. LED power on / Adjust / Scan
2. Readjust / Autoscan button
3. Input
4. Output
5. Power: 110-120 Vac
To avoid the risk of electric shock, not open the
equipment.
2
1
3
4
4