Publicidad
Idiomas disponibles
Idiomas disponibles
The DC terminals may ONLY be used for charging 12 volt automotive type batteries.
The terminals are colored red to identify the positive (+) terminal and black to identify the negative
(-)terminal. the battery must be connected to -he-generator DC terminals with the proper polarity
(battery positive to generator red terminal and battery negative id the generator black terminal).
With DC Circuit Protector
DC circuit protector
The DC circuit protector(or DC Fuse) automatically shuts off the DC battery.
charging circuit when the DC circuit is overloaded, when there is a problem with the
battery, or the connections between the battery and the generator are improper.
the indicator inside the DC circuit protector button will pop out to show that the DC
circuit: protector has switched off. Wait a few minutes and push the button in Io reset the DC circuit
protector.
Connecting the batter/ cables:
①. Before connecting charging cables to a battery that is installed in a vehicle
Disconnect the vehicle's grounded battery cable.
△
The battery gives off explosive gases; keep flames and cigarettes away，
!
WARNING
Provide adequate ventilation when Charging or using batteries.
②. Connect the positive (+) battery cable to the battery positive (+) terminal.
③. Connect the other end of the positive(+) battery cable to the generator
④. Connect the negative (-) battery cable to the battery negative (-) terminal.
⑤. Connect the other end of the negative(-) battery cable to the generator
⑥. Start the generator.
With DC Fuse
(or DC Fuse)
9
Publicidad
