Publicidad
Idiomas disponibles
Idiomas disponibles
④. Visually inspect the spark plug. Discard it if the insulator is
cracked or chipped. Clean the spark plug with a wire brush if it
is to be reused.
⑤. measure the plug gap with a feels regauge.
correct as necessary by carefully banding side electrode.
The gap should be: 0.70-0.60 mm {0.026-0.031 in).
⑥. Check that the spark plug washer is in good condition, and thread the spark plug in by hand to
prevent cross-threading.
⑦. After the spark plug is seated. Tighten with a spark plug wrench to compress the Washer.
If installing a new spark plug, tighten 1/2turn after the spark plug Seats to compress the washer. If
reinstalling a used spark plug, tighten 1/8 -1/4 turn after the spark plug seas to Compress the
washer.
The spark plug must be securely tightened. An Improperly tightened spark plug
NOTICE
can become very hot and could damage the engine. Never use spark plugs
which have an improper heat range, use only the recommended spark plugs
or equivalent.
8. TRANSPORTING/STORAGE
When transporting the generator, turn the engine switch and the fuel valve OFF. Keep the generator
level to prevent fuel spillage. Fuel vapor or spilled fuel may ignite.
Contact with a hot engine or exhaust system can cause serious burns- or fires.
△
!
WARNING
Let the engine cool before transporting or storing the generator,
Take care- not to drop or strike the generator when transporting. Do not place heavy
objects on the generator.
Before storing the unit for an extended period:
- Be sure the storage area is free of excessive humidity and dust.
- Service according to the table below
18
Publicidad
