Publicidad
Idiomas disponibles
Idiomas disponibles
2. Install the spacer or the adapter depending on your accessory.
SNOW*
SHORT
CARRIAGE BOLT
ADAPTER
WASHER AND
NUT
WRENCH
SNOW*
with added
binding clearance
SHORT
CARRIAGE BOLT
ADAPTER
WASHER
AND NUT
WRENCH
1033297A - 3/18
All manuals and user guides at all-guides.com
ACCESSORY CHART
1. Find your accessory, and follow the diagram.
REMOVE THE UPPER PAD BEFORE CONTINUING.
1. Insert the short carriage bolt into the adapter
and attach to the accessory using the
accessory's hardware.
2. Secure the adapter and accessory to the
backbone using the wrench.
3. Reattach the pad.
4. Attach to crossbar, secure with bail and wheel.
5. Read warnings on final page!
ADAPTER POSITION:
If your factory bars are angled, and the adapter is not
flat against the accessory, loosen the carriage bolt and
rotate the adapter on the MightyMount.
You will need to remove the pad; be sure to replace it
once the bolt is tightened.
*
DO NOT INSTALL WITH SNOW ACCESSORIES ONTO ROUNDBARS.
This product cannot support ski/snowboard accessories when
installed onto symetrically rounded crossbars.
ADAPTER POSITION:
If your factory bars are angled, and the adapter is not
flat against the accessory, loosen the carriage bolt and
rotate the adapter on the MightyMount.
You will need to remove the pad; be sure to replace it
once the bolt is tightened.
WATER, BIKES, AND CARGO: continued next pages➤
REMOVE THE UPPER PAD BEFORE
CONTINUING.
1. Insert the short carriage bolt into the
adapter and attach to the accessory using
the accessory's hardware.
2. Secure the adapter and accessory to the
backbone using the wrench.
3. Reattach the pad.
4. Attach to crossbar, secure with bail and
wheel.
5. Read warnings on final page!
Publicidad
