Troubleshooting - Qlima FWK 1608 Instrucciones De Uso

VII
TROUBLE SHOOTING
To prevent unnecessary expense, we recommend that you always first carefully
consult the instructions for use. Take the wine cooler to your dealer for repairs if
these instructions do not provide a solution.
Symptoms
The wine cooler does
not cool.
The wine cooler does
not get cold enough.
The wine cooler seems
to make too much
noise
Frost is building up in
the unit.
Inside light flash
Possible cause
The unit is not plugged in. Plug in the unit.
The voltage is incorrect.
A fuse may be broken.
The temperature setting
may be incorrect.
The wine cooler may be
placed too close to a heat
source.
There is insufficient ventila-
tion.
The door is not completely
closed or the door seal is
not working properly.
Door opened too frequent-
ly or door open for too
long time
Too many bottles of a too
warm wine
Fan does not work
Bad ventilation
The unit is not leveled or
positioned properly.
There is insufficient ventila-
tion.
The unit is too close to a
wall or another surface.
Incorrectly placed bottles
There is excess humidity or
the interior temperature is
too low.
Set temperature higher
than indoor temperature
Automatic defrost function
is working
Solutions
Ensure proper voltage.
Have the unit's fuse replaced.
Make sure the set temperature
is correct.
Keep the wine cooler away
from direct sunlight or other
heat sources.
Place the wine cooler in an area
with proper ventilation and
clearances.
Close the door tightly. Do not
open the door frequently and
do not keep the door open for
extended periods of time.
Keep door closed as much as
possible
See chapter 'optimizing perfor-
mance'
Check plug, check fuse. Else: fan
motor might be broken: have
winecooler repaired
Position the winecooler with
better ventilation
Adjust the unit's feet and
ensure the product is level.
Allow sufficient clearance
around the unit.
Allow sufficient clearance
around the unit.
Make sure bottles are correctly
placed.
Turn off the wine cooler,
unplug it and remove the frost
buildup manually. Reconnect
the power once the ice has
thawed.
Adjust temperature
Normal function. No change
needed
4
47