Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Make sure that the blade is correctly centered, is sharp, and not damaged. An
off-center blade will cause vibration that could result in damage to the product.
Make sure that the locknut of the cutting equipment is tightened correctly.
Make sure that the transport guard for the blade is not damaged and that the
transport guard can be attached correctly.
Examine all couplings and connections. Make sure they are not damaged and
free from dirt.
Make sure that the bevel gear is filled correctly with grease, refer to
the bevel gear on page 17 . If not, use Husqvarna bevel gear grease.
Lubricate the drive shaft end in the lower shaft coupling.
Make sure that the air intake of the motor is not dirty. Clean the air intake with
compressed air.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
To lubricate the bevel gear
1. Remove the cutting equipment.
2. Put the product with the grease plug at its highest
position.
3. Remove the grease plug.
1920 - 001 - 28.11.2022
To lubricate
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
grease can cause damage to the bevel
gear.
6. Install the grease plug.
Daily
Weekly
Monthly
X
X
X
X
X
X
X
B
An incorrect quantity of
X
17
Publicidad
