HAMPTON BAY 672 099 Manual Del Propietário página 7

"Close-to-Ceiling" Mounting
1. Remove the canopy ring from the canopy by
turning the ring to the right until it unlocks
(Figure 5).
All manuals and user guides at all-guides.com
2. Remove the mounting plate from the cano-
py by loosening the four screws on the top
of the canopy. Remove the two non-slotted
screws and loosen the slotted screws. This
will enable you to remove the mounting
plate (Figure 6).
Canopy
Bottom
Cover
3. Remove the decorative canopy from the
bottom cover from the canopy by depress-
ing the three studs (Figure 8).
4. Remove three of the six screws and lock-
washers (every other one) securing the mo-
Figure 7
tor collar to the top of the fan motor housing
(Figure 9).
5. Place the rubber gasket over the remain-
ing three screws, route the wires exiting
the top of the fan motor through the canopy
ring (make sure the slot openings are on
top), then proceed to place the ceiling can-
opy over the collar at the top of the motor
(Figure 10).
6. Align the mounting holes with the holes
in the motor and fasten, using the three
screws and lockwashers removed in step 4
(Figure 10).
7. Tighten the mounting screws securely.
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS IN STEP 7 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
Figure 8
Collar
Ceiling
Canopy
Figure 9
Screw and
Lockwasher
(3 Screws)
Canopy
Ring
Rubber
Gasket
Figure 10
5.