Publicidad
Idiomas disponibles
Idiomas disponibles
Making the Electrical
Connections
REMEMBER to disconnect the power.
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
1. Connect the two green fan ground wires, lo-
cated on the downrod and mounting plate,
to the household ground wire. When using
"Close-to-Ceiling" mounting, there is only
one green ground wire from the ceiling
mounting plate since the ball/downrod as-
sembly is not used.
2. Connect the fan light supply (blue) wire to the
fan supply (black) wire to the black house-
hold supply wire as shown in figure 12.
3. Connect the neutral fan (white) wire to the
white neutral household wire.
4. After connecting the wires, spread them
apart so that the green and white wires are
on one side of the outlet box and the black
wire is on the other side.
All manuals and user guides at all-guides.com
5. Turn the wire connecting nuts upward and
push the wiring into the outlet box.
CHECK TO SEE THAT ALL CONNECTIONS ARE
TIGHT, INCLUDING GROUND, AND THAT NO
BARE WIRE IS VISIBLE AT THE WIRE NUTS, EX-
CEPT FOR THE GROUND WIRE.
ELECTRICAL DIAGRAMS ARE FOR REFERENCE
ONLY. OPTIONAL USE OF ANY LIGHT KIT SHALL
BE CUL LISTED AND MARKED SUITABLE FOR
USE WITH THIS FAN.
Figure 12
7.
Publicidad
