Publicidad
Idiomas disponibles
Idiomas disponibles
Requirements to the air supply
The pneumatic sabre saw works optimally at an operating pressure of 6 (4) bar, measured
at the air inlet. The distance from the air supply to the machine has to be adjusted to the
application conditions on site.
We recommend installing an oiler or a maintenance unit upstream the machine for
compressed air preparation. Use acid and resin-free lubricating oil, like SAE 5W - SAE 10W, for
proper functioning of the pneumatic sabre saw. Attention! Do not use viscous oil.
Use an antifreeze lubricant, e.g.:
-
"Kilfrost" ,
-
or "Kompranol N74" in winter and if the compressed air is very moist.
The supplied compressed air has to be free of:
-
Foreign particles,
-
humidity.
Pay attention that all hoses:
-
Have a cross section being large enough,
-
do not have any restrictions or buckles,
-
are designed for a minimum operating pressure of 6 bar,
-
are replaced regularly at preventative maintenance,
-
have an oil resistant inner surface and an abrasion-resistant outer surface,
-
are proved and specified to be non-conductive when being used next to electric
conductors.
Always use hoses, lubricating oil and antifreeze lubricants, which meet the local safety
requirements for use in areas exposed to explosion hazards.
Connecting the air supply to the pneumatic sabre saw
Remove the locking cap from the air connection 3 (see fig. 2). Connect the pneumatic hose
(not contained in the scope of delivery.
The size of the saw blade depend on the material of the work piece. During cutting, the saw
blade has to be cooled, respectively lubricated, with water, drilling emulsion, oil or cutting paste.
INSTALLATION
(sound absorver)
3
Air inlet
Fig.2
7
Exhaust
35
Publicidad
