EGAmaster 72984 Manual De Instrucciones página 37

All persons who are assigned to work with the machine are obligated to:
- always pay attention to the basic safety and accident preventing regulations.
- always read and follow the safety and warning notes in the operating instruction booklet.
Before working on or with the tool, read the safety instructions and follow the
instructions during operation.
Do not modify machine or machine tools and accessories after receipt. Permission from the
manufacturer must be obtained under observance and adherence of all safety instructions before
any modifications or alterations.
Use the machine only for its intended use. Observe the technical data of the equipment and the
ambient temperatures.
This machines are only desgined for commercial/ industrial use. Use only the manufacturer
genuine parts and accessories.
Pay attention to labels, restrictions of use and special instruction notes on the machine tools and
the machine itself.
Regularly check that the type plate and symbols on the machine are legible. If necessary, contact
the manufacturer to replace them.
Only operators with technical knowledge, trained by authorized responsible technical personnel
may install, adjust, operate, transport and store the machine.
Disassembly and assembly work as well as maintenance and service may only be carried out by
the manufacturer or qualified personnel.
Operate and maintain the machine as described in the operating instruction booklet.
Select, maintain and replace the wear parts and machine tools as described in the operating
instruction booklet of the machine.
Before each operation, make visual check of the machine and machine tools, as well as
accessories with regard to integrity and appropriateness for the application.
Never operate the machine if one or more parts (e. g. machine tools, cables, lines) are damaged,
if it is not working properly, if any damages can be identified or are to be suspected (e. g. after it has
been dropped). Replace damaged parts immediately.
Never remove protective devices from the machines where fitted and ensure they are in good
condition and properly adjusted before starting the machine.
A malfunction, which impairs operator safety, must be immediately removed. Never drop or insert
any objects into any opening.
Ground the machine to avoid static electricity. Keep compressed air free of oil.
Avoid damage by suction and deposit of dust, rust particles and paint particles - if necessary,
install a filter in front of it (danger of explosion).
Pay attention that the machine is cleaned from dust and deposits of rust particles and paint
particles before and after the work.
The machine must be protected against the thrust caused by the output jet.
SAFETY INSTRUCTIONS FOR PREVENTION OF WORKPLACE HAZARDS
OPERATOR OBLIGATIONS
BASIC SAFETY INSTRUCTIONS
37