Publicidad
Idiomas disponibles
Idiomas disponibles
Inspection and maintenance can be done by the operator, disassembly and reassembly of the
machine have to be executed by qualified staff only. Incorrect assembly can lead to danger of
accident for the operator and to defects on the machine.
Generally, pneumatic machines need little maintenance. If the following rules are observed, the
machine will have the expected long life-time and high reliability:
Regular check of exterior damages on the machine. Regular check of the pneumatic filter.
Use of grease/ oil free compressed air.
In case of disturbances we recommend sending the machine to the manufacturer.
Disassembly: refer to spare parts drawing.
Separate the machine from the compressed air supply prior to disassembling! Only qualified staff
is allowed to execute the disassembly and re-assembly.
After each maintenance check, if the technical specifications are adhered to!
Generally use genuine spare parts only. Otherwise you risk a decrease in machine performance
and a higher maintenance demand. There is no warranty for damages and liability is disclaimed, if
non-original spare parts and accessories are use.
Attention
Parts can be damaged when falling down!
Stick to the following procedure when disassembling the machine: Separate the machine from
the compressed air supply.
Remove the air guide item 2 from the housing item 1 by unscrewing the parts. Pay attention to
the order of the items: 16, 20, 17, 10.
Re-assembly:
Important
Clean all parts. Replace the damaged parts.
Basically the re-assembly is done in reverse order to the disassembly.
When working on or with the equipment, it is imperative to observe all requirements
in regards to waste- disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging
agents, such as
- lubricating grease and oil,
- hydraulic fluid,
- coolant,
- solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in suitable
containers!
DISASSEMBLY - RE - ASSEMBLY
ENVIRONMENTAL REGULATIONS
41
Publicidad
