Hama 00176578 Instrucciones De Uso página 7

included in the extent of delivery).
7. Continuing cables to the next built-in light
must correspond in terms of structure and
insulation to the operating mode. The
yellow / green (earth / PE conductor) cable
is not connected. Other lights are cabled
in parallel.
230 V
50 Hz
8. Close the junction box and push it into the
installation opening. Also ensure that the
cables are free of compressive and tensile
forces. Protect all cables and insulation from
any potential damage.
9. Position the built-in light at an angle and
rst insert a clamp into the installation
opening. The springs on the clamp are
very powerful and can cause injury if due
attention is not paid!
10. Now guide the second clamp into the
installation opening. The built-in light is
now slowly introduced all the way into
the installation opening. The force of the
clamps is su cient to hold the built-in light
in position.
11. No further xings are needed. For precise
alignment, the built-in light can be easily
repositioned and rotated. The internal part
of the light can also be swivelled.
12. Only reinsert the fuse once all built-in lights
have been installed.
Removal
1. Pull the built-in light out of the installation
opening on one side. Take care to ensure that
the clamp does not accidentally slip out of
the opening. Otherwise there is a danger that
ngers may become trapped.
2. First carefully remove one clamp, then the
other, from the installation opening.
3. The further removal process is carried out in
the reverse order to the installation process.
5. Getting started
• Download the Hama Smart Solution APP
from the Apple App Store or Google Play Store
• Open the Hama Smart Solution APP
• The rst time you use the app, you need to
register and create a new account. If you
already have an account, log in with your
access details
• The LED built-in spotlight starts to ash quickly
(if it does not, switch the LED built-in spotlight
ON and OFF again quickly 3 times)
• Now click the + at the top right-hand corner
and select Lighting, then your device.
• Con rm that the LED built-in spotlight is
ashing quickly.
• Now enter the name of your WiFi network and
the password and con rm.
• The LED built-in spotlight is now connected.
Once the connection is successful, the LED
built-in spotlight will stop ashing
• You can now set up, control and con gure the
WiFi Smart LED built-in spotlight with the APP
7