Steren BAF-1295 Manual De Instrucciones página 19

INSTRUCTIONS
Make all initial connections with the power switches OFF on all equipments. Make sure volume
level are all the way down, later you can adjust it.
1. Connect the polarized cable to electric current, then plug to the speaker.
2. Connect a microphone into MIC input through a 6.3mm or cannon connector.
3. Use Line IN connectors to plug a CD, ipod, MP3 or DVD player, among others.
4. Turn the devices on, a green LED will light on, indicating the equipment is in use.
5. Set the volume level on each device. Adjust the volume control on the speaker.
6. Set treble, and bass frequencies in accord to your necessities.
CASCADE CONNECTION
For this connection use a 6.3mm male / cannon female connector to RCA males / cannon male
cable. Also you can use our 255-606, 255-612 or 255-624 cables according your needs.
PLACEMENT
The powered speaker is designed to sit on the floor, a tabletop, or to fit on a standard tripod speaker
stand. Some recommendations are:
- Avoid placing the speaker in the corner of a room. This increases the low frequency output and
can cause the sound to be muddy and indistinct.
- Avoid placing the speaker against a wall. This, too, increases the low frequency output, though
not as much as corner placement. However, if you do need to reinforce the low frequencies, this is
a good way to do it.
9